Many people's water heaters have been used for a long time, and the water heaters have become very dirty, especially in the places we can't see inside. The reason is that a lot of scale has been accumulated in the water heater since it was used, and there is no active design to clean the scale. Therefore, we need to clean the water heater regularly. If you can't clean the water heater, let it Let me teach you.
The first step is to cut off the power supply of the water heater, then close the two triangle valves, and screw off the nut of the hot water port to prevent the hot water from flowing out. Next, screw the nut of the cold water port to drain the water from the cold water outlet. Conventionally, for a 50 liter water heater, the drainage takes about 1 hour.
Then connect the water pipe to the hot water port of the water heater, fill the water inside, and plug the cold water port, let the cold water bubble in the inner cylinder for a moment, and then discharge. Repeat the operation for several times until the water discharged from the cold water outlet becomes clean. After the above, we need to screw on the nuts on the cold water nozzle and hot water port, turn on the triangle valve, and turn on the hot water from the faucet After the water is clean, it can.
However, we should also pay attention here that the water temperature of the water heater should be controlled below 50 degrees before cleaning, so that the water temperature can be directly discharged into the drainage pipe, which will not affect the sewer pipe. In order to clean the water heater, the sewage outlet with the water heater will also be opened together.
Source: Jiangmen magnetic energy water heater http://www.konryt.com/
10-17
What causes the trip of Jiangmen storage type magnetic energy electric water heater
The sudden trip of electric water heater during heating is mainly due to the following reasons: firstly, the heating pipe and temperature sensitive switch probe conduct heat directly through the metal. If the heat conduction is too fast or too high, it will cause problems. At this point, it may be necessary to replace it. Secondly, the insulation function of the heating tube is reduced, so its insulation resistance is unstable. When the leakage current exceeds a certain value, it will act on the
10-17
How to clean Jiangmen magnetic energy water heater
Many people's water heaters have been used for a long time, and the water heaters have become very dirty, especially in the places we can't see inside. The reason is that a lot of scale has been accumulated in the water heater since it was used, and there is no active design to clean the scale. Therefore, we need to clean the water heater regularly. If you can't clean the water heater, let it Let me teach you. The first step is to cut off the power supply of the water heater, then close the two
10-17
Jiangmen magnetic energy water heater tells you the reason why the water heater runs slowly
Water heater hot water is not much, slow to boil water? The common electric water heater will appear this kind of shortcoming after using for as long as one or two years. The water is often not hot after half a day's operation, or the hot water will be gone before the bath is finished. Can you clearly buy a large number of liters of water heater? What is the problem? In fact, this is mostly due to the problem caused by the scale inside the electric water heater. After a long time of using the ke
10-17
The technique of removing the stain of Jiangmen magnetic energy water heater
As we all know, after a long time of use, all electric appliances that use electric heating tubes to heat water, such as electric water heaters, electric kettle, etc., simply produce scale and dirt on the surface of the electric heating tubes, and then reduce the heat exchange efficiency. If you can't take it out in time, it will not only waste the electric energy, but also shorten the life of the heating pipe due to poor heat conduction of the heating pipe, and even damage it due to overheating